astra h gtc turbo fell p1106

[opelmandk]

hallo hilfeee))) :roll: i mine auto hat ein nue opc leh lad und5500rpm laddryk
goes down bis 0.25 un fell code com und der box goes in emergency mode:shock: :evil: :roll:

 

[Tigra2.0 16V]

Hallo and welcome in this forum.

Is adapted to your software???

MfG Tigra2.0 16V

 

[OPC2013]

Så det handler om fejl.

P1106 Boost Pressure Sensor Sammenligning
P1106 ladetryk signalet er ikke inden for rammerne
P1106 Boost trykstyring fejl

Jeg havde engang ...

gange et link her ...

http://www.astra4ever.net/opel-kennt-den-fehler-nicht-t32252-s25.html

Jeg ved ikke, hvad fase du skal hen, eller hvis du har et generelt på det.

Jeg blev sat under den høje temperatur udstødning af fejl var Wech og kom aldrig tilbage ...


So it is about the errors.

P1106 Boost Pressure Sensor Comparison
P1106 boost pressure signal is not within limits
P1106 Boost pressure control error

I once had ...

times a link here ...

http://www.astra4ever.net/opel-kennt-den-fehler-nicht-t32252-s25.html

I do not know what phase you are going or if thou hast a general on it.

I was put under the high temperature exhaust of errors was wech and never came back ...

 

[opelmandk]

Hallo and welcome in this forum.

Is adapted to your software??? danke schøn))
yes it is remabed for the leh :

MfG Tigra2.0 16V

 

[opelmandk]

Så det handler om fejl.

P1106 Boost Pressure Sensor Sammenligning
P1106 ladetryk signalet er ikke inden for rammerne
P1106 Boost trykstyring fejl

Jeg havde engang ...

gange et link her ...

http://www.astra4ever.net/opel-kennt-den-fehler-nicht-t32252-s25.html

Jeg ved ikke, hvad fase du skal hen, eller hvis du har et generelt på det.

Jeg blev sat under den høje temperatur udstødning af fejl var Wech og kom aldrig tilbage ...


So it is about the errors.

P1106 Boost Pressure Sensor Comparison
P1106 boost pressure signal is not within limits
P1106 Boost pressure control error

I once had ...

times a link here ...

http://www.astra4ever.net/opel-kennt-den-fehler-nicht-t32252-s25.html

I do not know what phase you are going or if thou hast a general on it.

I was put under the high temperature exhaust of errors was wech and never came back ...

danke ich will get my remab tjekedd))

så you mean its get to hig temptur??

 

[OPC2013]

ja, det er bestemt ved emission temperatur. Det var år siden, da mig og de fejl 3.
du har en fase du skal hen på det, eller endda originale software?

 

[Samy]

This error code says that your boost is too high. There are two possible reasons for it.

1. Your turbosystem has a problem maybe the wastegate is stuck or the hose on the wastegate actuator isn't connected.
2. If you run a tuning software and the error occurs just after it the mappings could be and often be the problem. Faulty diagnose mappings or wrong timing mappings.

 

[opelmandk]

This error code says that your boost is too high. There are two possible reasons for it.

1. Your turbosystem has a problem maybe the wastegate is stuck or the hose on the wastegate actuator isn't connected.
2. If you run a tuning software and the error occurs just after it the mappings could be and often be the problem. Faulty diagnose mappings or wrong timing mappings.

ok thx for the replay i vil tjek those things)=)