EDS Phase 3.5

[CalTe]

Hi all, sorry for the English but my German language is not so good.

Ive just installed the 3.5 chip and the powerwheel with chip ver 6.23.
Allt electronic work is done by EDS so it should have been a "PlugandPlay" job.
I have written to Arno but no answeer yet.

Now to my problems
In steps 1 to 4 I have just 0,5 Bar boost (basic boost).
In step 5 the engine cuts out, it dies.
The airmassmeter is getting hot in step5.
The ABS and the 4x4 varninglight is coming on (solved).
Lambda signal just on steps1 - 4.

What the fuck is going on ;-)

mfg
CalTe

 

[Nereuss]

I think the Powerwheel modul is defect,

if you can read a little bit german, than search for Dampfrad or Dampfradplatine

 

[CalTe]

Thanks Nereuss for your try to help. I have allready searched on the German section but without success.

All the problems are now solved.
2 wires on the powerwheel was mixed up from EDS :evil:
Had to measure on all pins and wires then I switched and resoldered wire2 and wire3.