J
Jerry
- Dabei seit
- 30.04.2003
- Beiträge
- 2
- Punkte Reaktionen
- 0
I recently installed phase 3 but have a few issues:
>The boost setting on pos1 is 0.3 bar but it goes to 0.9 bar (overboost 1.2 bar) on pos2-5. Even with the racing switch it is on 0.9 bar. There is no difference in the boost settings between 2-5.
> The engine management light comes on (lambda sensor). This is good because it is picking up leaness but the boost pressure is not decreased by the phase kit. Still runs high pressure.
> On the road and dyno the car holds back when it goes to oberboost 1.2-1.3 bar. On the dyno graph the power is at 180kw at 4200rpm then drops down to 140kw and holds this to 5800rpm.
> On pos 1 there is no overboost so if I turn the actuator up so it boost 0.9 bar on pos1, on full throttle the car does not hold back.
>The fueling seems to be rich air/fuel ratio at high rpm is 11.8.
Can someone comment on these issues please.
>The boost setting on pos1 is 0.3 bar but it goes to 0.9 bar (overboost 1.2 bar) on pos2-5. Even with the racing switch it is on 0.9 bar. There is no difference in the boost settings between 2-5.
> The engine management light comes on (lambda sensor). This is good because it is picking up leaness but the boost pressure is not decreased by the phase kit. Still runs high pressure.
> On the road and dyno the car holds back when it goes to oberboost 1.2-1.3 bar. On the dyno graph the power is at 180kw at 4200rpm then drops down to 140kw and holds this to 5800rpm.
> On pos 1 there is no overboost so if I turn the actuator up so it boost 0.9 bar on pos1, on full throttle the car does not hold back.
>The fueling seems to be rich air/fuel ratio at high rpm is 11.8.
Can someone comment on these issues please.
